As part of Advanced settings, I can set Remove the 'static' resource messages from the page. I want to make it permanent so I do not have to do it every time. Please tell me where I can set it up.
You can make this change permanently in a number of places.
at page level.
Toggling the tick box for resources and/or static on and off
at clip level
Properties Tab > Page Resource Settings > Page Resource Loading
change this from 'use individual page settings' to 'Override to disabled'
at track level within a composition
Highlight chosen Track in Properties Tab > Page Resource Settings > Page Resource Loading
at composition level
Highlight Composition in Properties Tab > Page Resource Settings > Page Resource Loading
Page level is the lowest and will be overwritten going up the levels with composition level being the highest which will override all below.
If you are speaking about the one when recording with the Conductor, then those settings are not saved and need to be set every time you are recording. Btw, it is not a best practice to do that as some important requests might get into the Static section of the pages as the CloudTest paging algorithm for paging is not perfect.
Retrieving data ...