Threshold Settings

Document created by DPM Admin Employee on Jul 20, 2017Last modified by Dave Murphy on Sep 20, 2017
Version 3Show Document
  • View in full screen mode

Threshold settings allow you to place time parameters for data aggregation. Charts of results and monitor data aggregate at different levels depending on the overall length of time displayed on the X-axis.  By default, charts aggregate at the second level. If a chart displays more than 10 minutes of data, then it aggregates data at the minute level. If a chart displays more than 1440 minutes of data (24 hours), then it aggregates data at the hour level.  The steps below show how to change those thresholds.

Charting.SecondToMinuteAggregationThreshold

 

  1. On the CloudTest screen, select the lower panel Settings tab for the Main server.
  2. In the Service category, select Repository.
  3. Click Add.
  4. Add Charting.SecondToMinuteAggregationThreshold.
  5. Enter a Value in seconds.
For example, 1200 = 20 minutes.

Note: If the Value is set to a very large number, then, depending on the number of charts on a dashboard and the number of series in each chart, the browser might become stressed.

 

 

Charting.MinuteToHourAggregationThreshold

 

  1. On the CloudTest screen, select the lower panel Settings tab for the Main server.
  2. In the Service category, select Repository.
  3. Click Add.
  4. Add Charting.MinuteToHourAggregationThreshold.
  5. Enter a Value in minutes.

Note: If the Value is set to a very large number, then, depending on the number of charts on a dashboard and the number of series in each chart, the browser might become stressed.

Attachments

    Outcomes