Using Mass Target Change

Document created by Chris Sommerstad Employee on Jul 21, 2017Last modified by Avril Dsilva on Aug 14, 2017
Version 2Show Document
  • View in full screen mode

Mass target change provides the ability to change the target of all the messages or browser actions in a test clip at once.

Mass target change can be useful when two target sites are identical (e.g. from the root folder of the test site) but have changed physical location.

For example, a test environment target site that has changed physical location. For example, a test site that was on server1.yourhost.com moved to server2.yourhost.com. Similarly, mass target change can be used to re-adapt test clips between target sites on the same LAN.

Prerequisites

Ensure that the target to change to exists before using the Mass Target Change command in the Clip Editor.

You can create a new target via the Central list > Targets. Refer to Target for an overview.

 

To mass change the target for a test clip:

    1. In the Central list, select Test Clips, then locate and double-click the test clip to open it.

The Test Clips list shows the current Test Clips in the system.

  1. Select a message(s) or action(s) whose target you want to change.
  2. Click the Messages/Actions tab in the lower panel, right-click the target in the Included Targets list, and select the Mass Target Change command fromn the menu. The Mass Target Change dialog box appears.

  1. Find the replacement target in the list and then click OK.

The target is replaced for the selection(s).

Attachments

    Outcomes